3
Admissible environmental conditions
The projector was engineered and produced to function in outdoor areas with an air temperature ranging between 0° and 35°C
and with a humidity level between 30 and 90%.
When choosing the installation, please make sure that the device is not exposed to extreme heat or in small area.
Power supply
Connect the fixture to the mains. See the table and the drawing for the colours of the connection cable.
Do not power the projector with a dimmer circuit
When in doubt, consult a qualified electrician.
The projector can be feed with voltage between 210Vac and 240Vac (on the projector body is specified if 50 or 60 Hz). Over-
voltage caned damage the electronic parts of the projector or reduce the lamp life. It is advised to check the electric system
before installation.
When the projector is switched on, the starting current is proxy double from the nominal current. After one minute the lamp
has beam switched and the current absorbed goes down to 1.8A (230V).
The projector is complete grounded, it is necessary to connect the grounding system to the projector.
Protect the electric system with highly sensitive differential circuit breaker, 30mA.
The projector has in its inside a fuse, if a power failure should accur, that breake the power supply, if damage change it with a
fuse of the same size.
Attention, the ignitor circuit inside the projector have a very high voltage, over 4.5KV.
