Mounting Options:
Mounting Options Diagram:
The SBLS series can be mounted permanently or via suction cups. The mounting brackets can be
secured on to the light bar with a flexible swivel angel of 117 degrees or in a fixed position with the
mounting surface side of the mounting bracket being perpendicular to the LED lenses of the light bar.
Replacing Light Modules:
The SBLS series are composed of replaceable 4W LED light modules. The light modules can be
replaced in the case of it becoming defective and in the case which the user wishes to have a
different color/module layout than the factory default. Please note that more than one module
may need to be removed in order to access the water tight quick disconnect plugs.
Mounting with Suction Cups Diagram:
Mounting with Suction Cups:
Install the suction cups onto the mounting brackets.
Secure the mounting brackets onto the strobe light unit by using the bolt, split washer, and
washer provided. Do NOT tighten the hardware all the way.
Adjust tilt angle of the light bar prior to tightening the hardware securing the mounting
brackets to the light bar.
1.
2.
3.
Permanent Mounting:
Permanent Mounting Diagram:
Secure the mounting brackets onto the strobe light unit by using the bolt, split washer, and washer
provided. Do NOT tighten the hardware all the way.
Place the mounting brackets against the desired mounting surface.
Mark the area where the mounting holes are to be drilled. Confirm that no vehicle parts could be
damaged by the drilling process.
Using a drill bit of appropriate size, drill three mounting holes. Thoroughly de-burr all hole(s).
Secure the mounting bracket to the desired mounting surface by using the mounting screws
provided.
Adjust tilt angle of the light bar prior to tightening the hardware securing the mounting brackets to
the light bar.
1.
2.
3.
4.
5.
6.
Mounting
CAUTION! Permanent mounting of this product will require drilling. It is
absolutely necessary to make sure that no other vehicle components could be
damaged by this process. Check both sides of the mounting surface before
starting. If damage is likely, select a different mounting location.
Online LED Store S2B Inc. ©2015 All Rights Reserved
