25
/ EN
You can change the auxiliary functions, speed
and temperature settings without stopping the
programme flow while the programme is running.
To do this, the change you are going to make
must be something that will be carried out after
the programme step that is running. If the change
is not suitable, relevant lights will flash 3 times.
C
INFORMATION
• If the machine does not proceed to the
spinning step, the Rinse Hold function
might be active or the automatic
unbalanced load detection system might
be activated due to the unbalanced
distribution of the laundry in the machine.
D
oor lock
There is a locking system on the door of the
machine that prevents opening of the door in
cases when the water level is unsuitable.
D
oor
light will start flashing when the machine is
switched to Pause mode. The machine checks the
level of the water inside. If the level is suitable, the
door light will turn off and the door can be opened
within 1-2 minutes.
If the level is unsuitable, the
door light will remain on and the door cannot
be opened. If you are obliged to open the door
while the Door light is on, you must cancel the
current programme. See
"Cancelling the programme"
Opening the door in case of power failure:
A
WARNING!
• Before opening the door, make sure that
there is
no water in the machine to avoid flooding.
Water
may be hot and could cause scalding.
Changing the selections
after programme has started
Switching the machine to pause mode
Press the Start/Pause to switch the machine
to pause mode while a programme is running.
The light of the current programme will flash on
the Programme Follow-up indicator, indicating
that the machine has switched to pause mode.
Also, when the door is ready to be opened, the
Door light will turn off in addition to the
programme step light.
Changing the auxiliary
function, speed and temperature
Depending on the step the programme has
reached, you can cancel or select auxiliary
functions. See “Auxiliary function selection”.
You can also change the speed and
temperature settings. See "Spin speed
selection" and "Temperature selection".
C
INFORMATION
• If no change is allowed, the
relevant light will flash 3 times.
