Page
6
www.howdens.com
INSTALLATION
HANGING YOUR EXTRACTOR
IMPORTANT: This instruction must be strictly adhered to. Failure to comply could result in over-
heating and serious damage to your appliance.
Fig 1.
Fig 2.
Note: It is recommended that the installation is carriedout by two people.
•
Remove the grease filters before proceeding with the assembly. This will give access to the lower
hood fixing holes and make the appliance easier to handle.
•
The recommended fixing height for the hood is 750mm above the worktop. This can be reduced to
a minimum of 700mm if required.
•
With reference to fig 1: mark, and drill the six holes required to mount the extractor and lower
chimney bracket to the wall. Use plugs and screws suitable for the wall construction (not supplied).
•
With reference to fig 2: the top two hood securing positions are keyholeslots. Screw these screws A
in first leaving approximately 2mm between the screw head and the wall.
•
With the help of an assistant locate the hood on these two screws, tightening if necessary.
Fixing Height Above Worktop
Recommended = 750mm
Minimum = 700mm
30
300
170
170
127
max 855
A
