Lamona LAM1763, Руководство по установке пользователя

Страница: 17 / 24

_ 17
User manual LAM1763
Clearances and dimensions – requirements
• No shelf or overhang of combustible material
should be closer than 650mm above the hob.
• There must be a minimum clearance of 50mm
between the edges of the hob and any side
walls; this clearance must be maintained up to
420mm above the worktop.
• When installing an extractor hood above the
hob, refer to its manufacturer’s instructions
Clearances and dimensions – requirements
• There must be a minimum clearance of 50mm
between the rear edge of the hob and the rear
wall. This clearance must be maintained up to
650mm above the worktop (unless otherwise
stated in your extractor manual)
560mm
50mm Min
50mm min
420mm min
490mm
Minimum distance
between carcasses must
be equal to width of hob
*
Minimum height to extractor
as recommend in extractor
instruction manual
*
50mm min between hob and rear wall
(>60mm to cut out aperture)
Fitting into worktop
Cut a hole in the work surface to the required size.
(560mm x 490mm) as illustrated above.
A clearance of at least 50mm should be maintained
between the cutout and any rear or side wall.
The worktop must be of heat-resistant material or
covered with heat-resistant material.
Protecting the cut-out
The types of chipboard used for work surfaces swell
relatively quickly in contact with humidity.
Apply a suitable sealant to the cut edge to protect it
from moisture ingress.
Self Adhesive Seal
Apply the self adhesive seal to the underside edges
of the hob glass. For best results, the seal should
be adhered along each side in turn, as close to
the edge as possible, and trimmed at each corner,
taking care to ensure a neat join.
This hob can be installed conventionally (glass
above the work top) or recessed into the work top
for a flush fit.
Conventional installation
Place the hob in the aperture, checking the hob
glass is covering the work top along all four sides.
Set the front edge of the appliance parallel with the
front of the work top.
Attach the securing clamps and screws shown in
the diagram, Tighten the screws so that the hob
is pulled down firmly against the worktop, thus
ensuring a good seal.
Recessed method
Recess the work top to the appropriate depth
(Approx 5mm) and shape to fit the hob (add 1mm to
overall glass size.
Insert the hob into the recess, ensuring that the
foam seal is sitting correctly.
Attach the securing clamps and screws shown in
the diagram, Tighten the screws so that the hob
is pulled down firmly against the worktop, thus
ensuring a good seal.
You may want to fill any gap between the hob top
glass and the work top surface with silicone sealant.
DO NOT fit silicone sealant under the glass hob
instead of foam seal.
Installation