Lamona LAM1761, Руководство по установке пользователя

Страница: 19 / 26

_ 19
User manual LAM1761
06 - Installation
General information
Installation should only be carried out by a qualified
installer or engineer.
Please keep to the following points most carefully;
Although every care has been taken to ensure
this appliance has no burrs, or sharp edges, we
recommend that you wear protective gloves when
installing and moving this appliance. This will
prevent injury.
The minimum distances to other appliances and
units are to be observed.
Wall surfaces above the work surface and
in the immediate vicinity of the cooking
hob must be heat resistant.
Laminated surfaces and the adhesive used for
fixing them must be heat resistant in order to avoid
any damage.
The space for air circulation, located
underneath and at the back of the hob
improves its reliability by ensuring that it
will cool down, efficiently.
Installations should be carried out in line
with the National Regulations applicable
with this product type.
Note: Avoid installing the appliance next to doors
and under windows. This will avoid the potential
for hot cookware being knocked off the hob when
doors and windows are opened (Risk of burns).
Built-in appliances may only be used after they have
been built-into suitable built-in units and surfaces
that meet the required standards.
Do Not - expose this product to contamination by
dust, building debris, sawdust etc, it is recommend-
ed that this product is stored in a clean environment
until ready to install. Before installation any dust,
building debris, sawdust etc should be vacummed
away to ensure no contamination will entre the unit.
Failure to follow this advice can cause the product
to fail or reduce the life of the product.
Positioning
Choosing your installation
• Make sure that the air inlets through the
ventilator grids underneath the hob are never
blocked.
Installing the hob over a unit with a drawer or
door
• The Hob’s air outlet is underneath work
surface. If necessary, remove the front
crosspiece of the unit to allow suitable
ventilation.
• We recommend that you install this appliance
in a work top which is a minimum 38mm deep.
• The hob can be fitted into a work top less than
38mm deep, but the 20mm gap between hob
base and appliance or cabinet partition must
be maintained.
Installation above an oven
• Refer to the manufacturer’s instructions for
clearances above the oven. We recommend a
minimum 20mm gap between the bottom of
the hob and appliance
40mm Hob
Worktop
Screw
50mm
Hob
Worktop
Screw
30mm
Hob
Worktop
Screw
Worktop
20mm
oven or partition
Hob
5mm
In the case of a Pyrolytic oven
• If installing the hob above a pyrolytic oven,
additional provision for air circulation /
ventilation may be required. Due to the
excessive temperatures attained during
pyrolysis, using the hob at the same time may
cause the thermal safety device within the hob
to operate.
Installation