EN
5
Items such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed articles
and clothes or pillows fitted with foam rubber pads should not be dried in the tumble dryer
Fabric softeners, or similar products, should be used as specified by the fabric softener instruc-
tions.
The final part of a tumble dryer cycle occurs without heat (cool down cycle) to ensure that the
items are left at a temperature that ensures that the items will not be changed
Never stop a tumble drier before the end of the drying cycle unless all items are quickly removed
and spread out so that the heat is dissipated
Do not store flammable fluids near the appliance.
Lengthy periods out of use.
If the appliance is not to be used for a lengthy period it should be disconnected from the electricity
and water supplies and the door should be left ajar to prevent unpleasant smells from building up
inside.
Important!
This appliance is easy to use.
However, for the best results it is important to read this manual carefully and follow all the instructions
before putting it into operation.
The manual provides the correct instructions for installation, use and maintenance, as well as giving
useful advice.
For Great Britain only
Warning
: this appliance must be earthed.
Fuse replacement
If the mains lead of this appliance is fitted with a
BS 1363A 13amp
fused plug, to change a fuse in
this type of plug use an
A.S.T.A
. approved fuse to
BS 1362
type and proceed as follows:
1. Remove the fuse cover (
A
) and fuse (
B
)
2. Fit replacement 13A fuse into fuse cover
3. Refit both into plug
Important:
The fuse cover must be refitted when changing a
fuse and if the fuse cover is lost the plug must not
be used until a correct replacement is fitted.
If the appliance is connected to the mains without using a plug:
It is necessary to install in the fixed wiring an all-pole disconnection device having a gap be-
tween contacts of at least 3,5mm. After installation the disconnection device has to be easy to
reach.
The connection to the mains must be carried out by a qualified technician in accordance to the
scheme shown below and the regulations in force
L
= b ro w n
N
= b lu e
= y e llo w -g re e n
In the event of damage to the supply cord, it has to be replaced by the manufacturer or an au-
thorized technical service centre in order to avoid any risk.
The manufacturer declines all responsibility
for injury or damage caused by failure to
comply with the above regulations or deriving from tampering with even just one part of the
appliance and the use of non-original spare parts.
