Lamborghini Caloreclima NINFA N LOW NOX 24 MCS, Инструкция по использованию, установке и обслуживанию

Страница: 75 / 144

NINFA N LOW NOX 24 MCS
75 EN
cod. 3540R880 - 01/2009 (Rev. 00)
Lighting power adjustment
To adjust the lighting power, switch the boiler to TEST mode (see sec. 3.1). Press the DHW buttons (details 1 and 2 -
fig. 1) to increase or decrease the power (min. = 00 - max. = 60). Press the RESET button within 5 seconds and the
lighting power will remain that just set. Exit TEST mode (see sec. 3.1).
Service menu
The card is equipped with two Menus: one for configuration and the other for Service.
The configuration Menu is accessed by pressing the DHW buttons together for 10 seconds. 3 parameters modifiable
only from card for security reasons are available.
To exit the configuration Menu, press the DHW buttons together for 10 seconds.
The card Service Menu is accessed by pressing the Reset button for 10 seconds. Press the Heating buttons to select
"tS", "In", "Hi" or "rE". "tS” means Transparent Parameters Menu, “In” Information Menu, “Hi” History Menu, and “rE”
History Menu Reset. After selecting the Menu, press the Reset button to access it.
"tS”- Transparent Parameters Menu
The card has 24 transparent parameters also modifiable from Remote Control (Service Menu):
Remote
control
Card Description of Transparent Parameters Range Default
NO P01 Power selection (for Low-Nox versions only) 0=24kW, 1=32kW, 2=37kW 0=24kW
NO P02
Air signal max. setpoint Offset (for Low-Nox versions
only)
-20 - +20 Pa 0 Pa
NO P03 Lighting step after flame detection 0=Normal, 1=Low-Nox 0=Normal
Remote
control Card Description of Transparent Parameters Range Default
01 P01 Gas type selection
0=Natural gas,
1=LPG
0=Natural gas
02 P02 Boiler type selection 1-3
1=instantane-
ous combi
boiler
03 P03 Absolute min. power 0-100% 0%
04 P04 Lighting power 0-60% 50%
05 P05 Not used Do not modify 0
06 P06 Heating train 1-20°C/min 5°C/min
07 P07 Heating pump Post-Circulation 0-20 minutes 6 minutes
08 P08 Heating standby time 0-10 minutes 2 minutes
09 P09 Max. heating power 0-100% 100%
10 P10 Pump operation
0=Post-Circulation
1=Continuous 0=Post-Circu-
lation
11 P11
Pump shutdown temp. during Post-Circ (P02=1) 0-100°C 33°C
Pump shutdown temp. during Post-Circ (P02=2) 0-100°C 20°C
Pump shutdown temp. during Post-Circ (P02=3) 0-100°C 20°C
12 P12 Heating user max. setpoint 31-85°C 85°C
13 P13 DHW pump Post-Circulation 2-255 seconds 30 seconds
14 P14 DHW standby time 2-255 seconds 120 seconds
15 P15 DHW max. power 0-100% 100%
16 P16
DHW user max. setpoint (P02=1) 55-65°C 55°C
DHW user max. setpoint (P02=2) 55-65°C 65°C
DHW user max. setpoint (P02=3) 55-65°C 65°C