Lambo Doors Canada Chevrolet Camaro 1993, Инструкция по эксплуатации, Страница: 5 / 11

4) Modify Apron:
In order for the new Vertical Door Inc.
system to sit properly you will have to
cut the apron (about 5” in length and
1”-3” in depth). After cutting the apron
use a grinder to remove any sharp
edges. (VDI not responsible for any
errors)
Use a 10mm bolt to remove the fender
hold down as showed.
5) How to gain wire slack:
Wire slack is needed for the new
Vertical Door Inc. system to fully
open, wire slack will be gain from
inside the door.
Door panel removal:
You will have to remove the door
panel to gain wire slack.
Remove the covers and the screws.
Note: on models with power windows use the fork to pry the control panel
from the door and disconnect the wire harnesses.
Once all of the screws are removed, detach the trim panel from the door,
working around the door with a plastic trim panel tool to disengage the clips,
disconnect any electrical connectors and remove the trim panel from the
vehicle by lifting it up and away form the door.
With the door panel off remove the speaker, inside the hole you will find a
plastic clip that holds down the wires, remove the clip these will give you
the needed wire slack.
NOTE: on models with power
windows you will have to add (2)
extra cables as showed.