Lambda Labs CX-3A, Руководство пользователя

Страница: 19 / 25

Lambda Labs - Professional Acoustics CX-3A Manual
2.2.3. Second Independent Safety Link
If the loudspeaker is to be flown, the loudspeaker must be secured with a Second Independent Safety Link. This link is to be
attached to the back of the CX-3A. To prepare the loudspeaker accordingly, follow the steps as explained below:
1. Remove the M10 DIN 7991 screw from the
top of the loudspeaker with a ratchet or an
electric screwdriver. Keep the screw at a safe
place to make it possible to use again later.
2. Insert the M10 Eye Bolt and screw it in
completely. Use your manual force or a
suitable screwdriver to move the Eye Bolt to
a parallel position to the long side of the
loudspeaker. Do not over-tighten it, as the
Eye Bolt could enter the wood and damage
the speaker surface.
www.lambda-labs.com ! 18
• Ratchet or electric
screwdriver
•HEX BIT Number 6 (Wrench
Size 6mm)
R
Danger:
Do NOT use the 10mm Eye Bolt as a rigging item to fly the speaker with it! Use it
ONLY as a Second Independent Safety Link! When loading the 10mm Eye Bolt in an 90°
angle, the
WLL is 70kg with a Safety Factor of 1:5 !
R
DANGER!
Size: 40 mm
WLL: (90° load) 70kg
SF 1:5
DIN EN sim. 580
10 mm Eye Bolt
Danger: Always set the flange to 0 ° before lifting and setting up the loudspeaker! Make sure that
the loudspeaker does not tilt accidently when setting up and positioning on the respective loudspeaker
stand! Always make sure that the loudspeaker stand is properly set up and provides sufficient
stability. When using a distance rod mounted on a subwoofer, the loudspeaker on the top of the rod
should never be heavier than the subwoofer itself!
R DANGER!