Extension Kit p/n: 000008 rev A
2
doc: 400009 copyright© 2019 Lakeside Recreation, LLC
3. Assemble the added Middle Foot and Spacer to the Extension Beam towards the middle of the long length of
connected beams using 2 sets of 3.25” 3/8-16 bolts, washers, and nuts.
Install the Longer Winch Strap
The standard Shore Ramp comes with a 20’ winch strap. The Extended Shore Ramp is about 22’ in length and requires a
longer strap. Remove the 20’ strap from the winch and replace it with the 25’ strap provided in this kit.
Installation Notes for Extended Shore Ramp
The Shore Ramp PWC-50 is intended for the storage of personal watercraft on gently sloping firm sand, soil, or turf.
The Extended Shore Ramp is not intended nor structurally strong enough to support the weight of a PWC without being
supported by the added middle foot. It may be necessary to grade the underlying soil/sand so as to provide a straight
slope along the length of the ramp. This may involve either building up the grade under the middle of the Extended
Shore Ramp, or removing any soil that is humped up too high under the middle of the ramp.
If using the Extended Shore Ramp to span from the water to the top of a low sea wall, rip-rap, or dock, it will be
necessary to build a structural support for the middle of the ramp. Any such support must be sturdy, stable, and
durable. In such cases, it is recommended that the Shore Ramp be fastened to the structure using bolts installed
through holes drilled near the end of the Front Foot and Middle Foot.
IMPORTANT: The Extended Shore Ramp MUST be supported in the middle – it is not strong enough nor intended to
span its entire length unsupported and hold the weight of a PWC.
CAUTION: The Extended Shore Ramp MUST be securely supported across the entire width of the added Middle Foot
to provide lateral stability so as to avoid the hazard of the PWC tipping to the side.
CAUTION: Do not use the Shore Ramp on loose rock or any unstable ground where it may slide down or tip to the
side.
