Extension Kit p/n: 000008 rev A
1
doc: 400009 copyright© 2019 Lakeside Recreation, LLC
Extension Kit 7.5 (M4)
Assembly & Use Instructions
p/n: 000008
Lakeside Recreation LLC
www.lakesiderecreation.com
IMPORTANT NOTE ABOUT STAINLESS FASTENERS
Stainless fasteners may gall and seize up (cold weld) if assembled without lubrication. Be sure to apply a dab of the
supplied anti-seize compound to the threads of each stainless bolt prior to assembling the nut.
Assembly
If the Shore Ramp is not yet assembled, reference these instructions to incorporate the Extension Beam in between the
Keel Beam and Front beam as you assemble the Shore Ramp.
If the Shore Ramp is already assembled, start by removing the 8 bolts on the Keel Beam (rearward end) of the two
Connector Plates that attach the Keel Beam to the Front Beam. The Extension beam will be inserted between these two
sections. Retain the fasteners for re-use.
1. Unpack the Extension Kit box (and the Shore Ramp box) and confirm that all the parts are present according to the
parts lists.
2. Lay the Keel Beam, Extension beam, and Front Beam on a flat surface end to end, with the bottom access openings
facing up. Assemble them together using the Connector Plates, and 32 sets of 1.00” 3/8-16 bolts, washers, and nuts.
Note that 16 sets of bolts, washers, and nuts are supplied with the Shore Ramp Kit, and 16 more with the Extension Kit.
Get all the bolts inserted and the nuts started before tightening any of them. Tighten all 32 sets of fasteners firmly.
