The profile illustration at left shows the
proper placement of the mirrors and screws.
After the mirrors are screwed into place,
finish tightening the bolts to secure your
safety bar.
Important Cleaning
Instructions
Your unbreakable mirrors are made of a
special plastic. Although it is shatterproof, it
can be scratched if improperly cleaned. Do
not use paper towels or any other rough
cloths on the mirror surface.
Only use a cloth and warm water to clean
the mirrors.
mirror
safety bar
washer
mirror screw
Lakeshore
®
LEARNING MATERIALS
Installing the Unbreakable Mirrors
It does not matter which mirror you use as the top or bottom mirror.
Both mirrors come with a protective plastic coating. Do not remove the
plastic until directed.
Place a mirror on top of the bar so the screw holes are at the top. Be
sure the bottom of the mirror fits in the slot between the back of the
safety bar and the wall. Also, be sure the sides of the mirror are flush
with the sides of the bar.
With the mirror in place, use a pencil to mark the positions of the holes.
Remove the mirror and make three
1
⁄
16
"-wide pilot holes with the drill.
Remove the plastic coating from the mirror. Put the mirror back in place
and secure it with three washers and three 1
1
⁄
4
" screws, as shown below.
Tighten the screws with a Phillips screwdriver.
Follow the same steps to install the bottom mirror, only be sure the screw
holes are on the bottom, toward the floor. Also, make certain that the
mirror fits in the slot between the safety bar and the wall. Remember to
remove the plastic coating
before
you secure the mirror to the wall.
3
front of mirror
wall
washer
mirror screw
