O & M Manual – Insulated Case ATS Rev: October 2020
Publication Number:
MN0100700E
Version: V10.01.20
Page 43
7.
The new screen will read Editor – Schedule – Bank 1 – Weekly.
Figure 31 - Bank 1 - Weekly
8.
To change from Weekly to Monthly, press the
button and the Weekly text will start
blinking. If Weekly generator exercising is required, skip to step 11.
9.
Press the Up arrow above to the
button, and the text will change to "Monthly". NOTE:
if the text already says "Monthly" and "Weekly" is required, press the down arrow below to
the
button.
10.
Press the
button to select.
11.
Press the Down arrow below to the
button once.
12.
The new screen will read Editor – Schedule – Bank 2 – Weekly.
13.
If this schedule is being used, repeat steps 8 thru 10 to change Bank 2 settings.
14.
Press the Down arrow below to the
button once.
15.
The screen will now show a screen like Figure 32 - Schedule Setup shown below.
Figure 32 - Schedule Setup
16.
To make a change to (1-1) Bank 1, set 1, press the
button and the text in the same
location as "Transfer to S2" will start blinking.
17.
Use the Up / Down arrows around the
button to change the setting.
18.
Use the Right / Left arrows around the
button to increment to the next selection (next
selection will start blinking).
19.
Once changes are complete, press the
button again to finalize the changes to (1-1)
Bank 1, set 1, and the settings will stop blinking.
20.
There are 7 other sets to Bank 1 that may be set if applicable: (1-2), (1-3), (1-4), (1-5),
(1-6), (1-7), (1-8).
21.
There is a Bank 2 with 8 sets also if applicable: (2-1), (2-2), (2-3), (2-4), (2-5), (2-6), (2-7),
(2-8).
22.
If additional generator Exercising dates are required, repeat steps 11 thru 19 for additional
exerciser banks/sets.
