Lakeland TO GO 61783, Инструкция пользователя, Страница: 9 / 16

9
PROGRAMMING YOUR DIGITAL TO GO COFFEE
MACHINE
SETTING THE CLOCK
• You can set the clock on your coffee machine at anytime whilst the appliance is
switched on.
• Press the HOUR button, which is a 24 hour clock (0Hrs – 23Hrs) and then the MIN
button to set the correct time.
• Press and hold the buttons to scroll through the numbers quickly. When the number
displayed is getting close, release and press the appropriate button to increase one digit
at a time.
SETTING A PRE-SET AUTO MODE
• Remember to put in your coffee and water in advance.
• To confirm the automatic time to start brewing, simply press the PRO button and the
time you have set will appear on the control panel.
• Your coffee machine will automatically begin brewing at the set time. When the
brewing cycle begins the red light will illuminate and flash, to highlight that the coffee
machine is in operation.
• To cancel the Pre-set Mode, press the PRO button for about 3 seconds to cancel and the
word AUTO will disappear from the control panel.
• When the brewing cycle has finished the control panel goes off and just the time is left
on.
• To reset for the next time i.e. the next morning, press the PRO button and AUTO will
appear on the control panel.
WARNING: If after 10 minutes the coffee marker has not cooled down completely, the
water tank may have overheated. Open the lid with care as steam will escape and could
causes scalds of burns.
PLEASE NOTE: If you try to restart the coffee machine before it has completely cooled, it
may result in an incomplete cycle. The appliance has a thermal reset switch to prevent it
from overheating and may shut down.
• To set an automatic time for a brewing, first press the PRO
button. PROGRAM will appear in the top left of the control
panel. Next set the time you want your coffee to start brewing
by using the HOUR and MIN buttons, following the steps above
of ‘Setting The Clock’.
• Once time has been set AUTO will appear at the top of
the control panel to show it is set to Auto mode and the
left LED will be green.