Place the cover in position and use the provided 5 screws to
secure the cover to the light fixture. Tighten them loosely
first then tighten them fully.
Mount the light to suitable surface edge or corner. Use
provided Screws or use your own suitable screws, bolts &
nuts to fit your material and application requirements.
6
PO BOX 414
105 W. Simon St.
Laotto, IN 46763
Phone: 260-918-2758
Fax: 260-918-3540
E-mail [email protected]
www.lakelite.com
www.solarpilinglites.com
NOTE: Gently start the screws to ensure
the threads catch. You may also turn
them in reverse and then forward to
catch the threads safely.
Example Hand Wood Rail
Change brightness/power level at night by waving the
magnet over the solar panel
Holding the magnet for 5-seconds in the activation area
will change to the next LED color. You may then change
between brightness/power levels on that LED color.
Power Setting
* Run Times
100%
6-8 hrs
80%
7-9 hrs
65%
10-12 hrs
50%
13-14 hrs
35%
15-17hrs
20%
17-22 hrs
OFF
OFF
Holding for 5-seconds
Changes LED color
* Note:
Run times will vary significantly based on
factors such as; Sun Exposure, Season, Geographic
Location, Shading, Installed Location/Position, Battery
Condition, Brightness Setting, etc… The following run
times should only be used as a general reference and
are not guaranteed. Consider your local environment.
8
NEW MAGNET
SWITCH OPERATION
CHANGING BRIGHTNESS LEVELS
Wave the magnet over the solar
panel at night until you find the
activation area which changes
the brightness level.
Make a quick up & down motion
over this area to change between
brightness levels and OFF.
NOTE:
moving too slowly may
activate the magnet switch
multiple times going through
multiple levels at once. A quick
motion will help!
CHANGING LED COLORS
Hold the magnet over the
activation area for 5 seconds
until the LED color changes
SOLAR RAIL LIGHT
– 7”
MODEL: LL-SRL-7-S-WBA
5
7
