Laird Sentrius RG1 Series, Руководство по настройке

Страница: 5 / 27

https://www.lairdconnect.com/iot-devices/iot-sensors
5
© Copyright 2019 Laird. All Rights Reserved
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610
To use the gateway, you must power it up and access the web interface via the Ethernet port. To do this, follow these steps:
Follow the label on the box and connect the three antennas. Refer to Antenna Configuration for additional information.
Connect the power supply (see #2 in Figure 2).
Connect the gateway to your router (#3 Figure 2) using the Ethernet cable (#1 in Figure 2).
Your gateway is now connected and ready.
Figure 2: Connecting the gateway
To configure the antenna properly, do the following:
Attach the two shorter antennas to the 2.4/5.5 GHz (Wi-Fi) ports.
Attach the third and longer antenna to the 868 MHz/900 MHz (LoRa) port.
Figure 3: Antenna configuration
3
2
1