Laird Sentrius BT710, Руководство пользователя, Страница: 8 / 19

https://www.lairdconnect.com/iot-devices/iot-
sensors/sentrius-bt7x0-tracker-multi-sensor
8
© Copyright 2020 Laird Connectivity, Inc.
All Rights Reserved
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610
The tracer is equipped to trigger alarms at one of 3 distances from other tracers. These
ranges are referred to as
Range A , Range B , and Range C . Each range has its own
configurable RSSI threshold, providing flexibility to trigger different alarm indicators depending
on distance from remote tracers. Using the BT710 mobile app interface, tap and drag the letter
corresponding to the range to adjust, then fill in corresponding fields below to setup the alarm
configuration. Alarm 1 and Alarm 2 options allow setting different alarm indicators based on
the amount of time a remote tracer has been within the specified RSSI range.
The ranges are limited to be at least 4dBm apart from each other. The minimum range is -30
dBm (only
Range A can be set to this value, due to the 4dBm range threshold difference). The
maximum alarm range is -95 (only Range C can be set to this value, due to the 4dBm range
threshold difference).
Several indicator styles are available providing control over how alarm LEDs, audible tones, and vibration motor feedback are
activated when an alarm is triggered. These styles are configurable using the Alarms tab of the BT710 mobile application.
When configuring the alarm style, the BT710 mobile application will trigger the new alarm style on the BT710 tracer to show
the new alarm style
(note, “Save Changes” must still be pressed in order to apply the new alarm style).
Alarms are defined both by duration of proximity (Alarm 1 vs. Alarm 2) and by signal strength (RSSI) of each remote tag.
Indicator styles may be selected independently for Alarm 1 and Alarm 2 conditions. The following table (
Table 2 ) describes the
styles available for each alarm indicator.
Table 2: Alarm indicator styles
Indicator Style Description/Pattern
Red Alarm LEDs Off Red Alarm LEDs remain off
Style 1 LEDs are lit in a clockwise pattern
Style 2 All red LEDs blink in unison
Style 3 Top/bottom fast blink; left/right fast blink
Style 4 Left/right fast sweep of red LEDs
Speaker Indicator Off No tones are emitted by the speaker
Style 1 Three fast chirps
Style 2 Three buzzer tones
Style 3 Two double-beep tones
Style 4 Four bright tones, repeated two times
Vibe Indicator Off No vibration will be triggered by the vibration motor
Style 1 One long vibration
Style 2 Two vibrations
Style 3 Several short-pulsed vibrations
Style 4 One long ripple vibration
Alarm Intensity Low Lowers intensity of speaker and vibration indicators
High Normal intensity of speaker and vibration indicators
The tracer can be cleaned with a mild, non-abrasive detergent. The tracer is not IP-rated/waterproof, so do not immerse it in
water or cleaning fluids.
The tracer does not require any calibration.