KEY
DISPLAY
DESC
SIZE
QTY
7
FLAT WASHER
1/4
"
2
11
HOSE CLAMP
2
2
ARTICULATIN G
ARM
1
WALL / MAST
1
MOUNT
3
ANTENNA
1
MOUNT
9
PLASTIC WALL
#
8
4
ANCHOR
10
SS MACHINE
#8-18 x 3/4"
4
SCREW
5
MACHINE SCREW
1/4
"
-20 x 1-1/4"
2
6
SS SPLIT LOCK
1/4
"
2
WASHER
8
SS HEX NUT
1/4
"
-20
2
ASSEMBLY
Install the articulating mount to the antenna back plane, as
shown in Figure-1:
1. Find the molded antenna mount (3) and four 8-32 nylon lock
nuts (4). Use the nuts to attach the mount to the exposed
studs on the back of the antenna.
2. Find the molded articulating arm (2). Also, find a 1/4"-20 x
1-1/4" machine screw (5), 1/4" lock washer (6), 1/4" flat
washer (7), and 1/4"-20 hex nut (8). Use hardware to secure
the molded arm to the antenna mount as shown in Figure-1.
3. For installation on flat surfaces, find the molded wall/mast
mount (1) and use it as a drill template to mark hole locations.
Drill four 3/16" diameter pilot holes and install wall anchors
(9). Install the mount using four 8-18 x 3/4" self-tapping
screws (10).
4. For pole or mast installations, find two worm clamps (11) and
install as shown on the molded wall-mast mount (1). Encircle
pole with each band and tighten.
5. To attach the antenna assembly to the wall/mast mount, find
a 1/4" x 1-1/4" machine screw (5) and install a 1/4" lock
washer (6) and a 1/4"- flat washer (7) as shown.
Use the screw to attach the free end of the articulating
arm to the mount, securing in place with a
1/4"-20 nut (8).
6. Loosen 1/4"pivot screws as needed to position
antenna for desired azimuth and elevation
steering. When antenna is adjusted,
tighten all hardware securely.
Figure-1
4
HEX NUT
SS / Nylon
1
4
8/32"
