BL600-Sx
Single Mode BLE Module
Americas: +1-800-492-2320 Option 2
Europe: +44-1628-858-940
Hong Kong: +852-2923-0610
www.lairdtech.com/bluetooth
25
CONN-UM-BL600_v1_0
5.8.3.1
Analog Interface (ADC)
Signal Name
Pin
No
I/O
Comments
AIN – Analog Input
2
I
This interface is an alternate function on each pin, configurable
by
smart
BASIC. AIN configuration selected using GpioSetFunc()
function.
8, 9, 10 bit resolution. Voltage scaling 1/1, 2/3, 1/3.
AIN – Analog Input
4
I
AIN – Analog Input
5
I
AIN – Analog Input
6
I
AIN – Analog Input
7
I
AIN – Analog Input
8
I
5.9
nRESET pin
Signal Name
Pin
No
I/O
Comments
nRESET
22
I
BL600 HW reset (active low). Pull the nRESET pin low for
minimum 100mS in order for the BL600 to reset.
5.10
nAutoRUN pin
Refer to section
nAutoRUN pin and Operating Modes
regarding operating modes and the nAutoRUN pin.
Self-contained Run mode
Interactive / Development mode
5.11
Miscellaneous (Hidden JTAG)
The BL600 SW consists of:
BL600
smart
BASIC runtime engine FW (loaded at production, may be upgraded customer).
BL600
smart
BASIC application script developed by customer (loaded through UART by customer).
To allow customer the capability to upgrade the BL600
smart
BASIC runtime engine FW, to the latest version
released from Laird), the current
smart
BASIC runtime engine firmware (v1.1.50.0) only allows this upgrade via
the hidden 2-wire (JTAG) interface. Future releases will support upgrading
smart
BASIC runtime engine FW
over UART.
Signal Name (hidden name)
Pin No
I/O
Comments
nRESET (SWDIO)
22
I/O
NC (SWDCLK)
23
I
Connect 12 K resistor to GND (for current silicon only).
Laird can supply JTAG J-link programmer for this.
Only requirement is that the customer should use the following JTAG connector on the host PCB.
The JTAG connector MPN is as follows:
Reference
Part
Description
JP1 Note1
FTSH-105
Header, 1.27mm, SMD, 10-way, FTSH-105-01-L-DV Samtech
Note 1: Reference on BL600 development board schematic.
schematic wiring only for the JTAG connector and BL600 module hidden JTAG pins.
