Laird 450-00107-K1, Руководство пользователя

Страница: 11 / 52

Sentrius RG191+LTE
User Guide
https://www.lairdconnect.com/ 11
© Copyright 2020 Laird Connectivity.
All Rights Reserved
Americas : +1-800-492-2320
Europe : +44-1628-858-940
Hong Kong : +852 2923 0610
3.1.2 Wi-Fi Quick Configuration
Note: This feature only works with firmware version 93.7.2.9 and newer . Please verify your Gateway firmware version
number and, if required, upgrade to a current version. Refer to Updating Gateway Firmware for additional information
regarding this upgrade.
The gateway includes a mode to allow you to configure without ethernet access, in the case that you wish to join a wireless
network.
Apply power to the gateway and allow to start, then perform the following:
1. Depress and hold the user button (see #2 in Figure 2 ) for seven seconds.
2. From a wirelessly enabled device perform a scan.
3. Connect to the access point RG191+LTE
29378B , where 29378B are the last six digits of the Ethernet MAC address
found on the label on the bottom of the gateway ( Figure 4 ).
The network is secured with WPA2 with a password that is the same as the SSID. We recommend that you change the
default password for security reasons. The password can be changed on the
Wi-Fi > Advanced web page.
Upon logout or client disassociation, Wi-Fi Quick Config shuts down and normal operation resumes.
4 L
OG INTO THE
G
ATEWAY
To log into the gateway web interface, follow these steps:
1. Determine the last three bytes of your
gateway’s Ethernet MAC address. This can be found on the label on the bottom
of the gateway; the last three bytes are highlighted ( Figure 4 ).
Figure 4: Bottom label (Standard GW
– Left, AS923 & AU915 Region Supported/Latest Version – Right)– last three bytes of
the Ethernet MAC address highlighted
2. Enter the URL into the web browser to access the web interface. For example, for the gateway used in this guide, the
URL is https://RG191+LTE 29378B .local
., where “29378B” are the last six digits of the Ethernet MAC address. In Wi-Fi
quick config mode, the gateway can also be accessed via the IP address at https://192.168.1.1
3. Accept the self-signed security certificate in the browser.
4. Click
Advanced ( Figure 5 ).