NETGUARD
Operation
1. Connect the Netguard cable with the target computer and router (or other Ethernet
outlet).
2. Connect DC5V adapter to Netguard receiver. The power LED should be on.
3. Press the OFF(stands for block off) button of the remote controller, the status LED on
the receiver turns on, indicating that it is ready to access Internet.
4. Press the ON (stands for block on) button of the remote controller, the status LED on
the receiver turns off, indicating that access Internet is blocked.
Specifications
•
Operation Distance
With the antenna inside the receiver box, the netguard can be operated by the remote
controller with distance no less than 20 meters.
With the antenna outside the receiver box, the operation distance is no less than 30
meters.
•
Power Supply for AC/DC Adapter
Input: AC120V±10%, 60Hz, 10W
Output: DC5V, 200mA
•
Cable Length
6 feet.
FCC Rules
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
Any changes or modification not expressly approved by the party responsible could void
the user's authority to operate the device.
Laipac Technology, Inc. |
www.laipac.com
|
Tel: 1-(905)762-1228 Fax: 1-(905)763-1737
4
