laguna MTSS000020, Руководство пользователя

Страница: 28 / 78

28
Miter fence locking screw
hole
Miter fence flip stop
The miter fence [Cross cut fence] is fitted into the sliding table slot and locating by
tightening the lock screw into the hole in the table slot. Fit the clamp shaft through the
casting into the “T” bolt and tighten.
The machine is provided with a fence stop [shown in the up and down position] that is
factory set. Some adjustment may be necessary and can be achieved by loosening the
lock nut, adjusting the bolt, and then re-clamping the lock nut.
Wooden block Flip stop
Flip stop
Assemble the clamp as shown by screwing the centre post into the “T” bar.
Note . The wood in the view above is resting on the wooden block at the front of the fence
and also on the flip stop.
The miter fence can be fitted to the far end of the table and a short “T” bolt is supplied
that can be used as a reference stop. You will have to move the cast iron miter angle to
the opposite of the fence extrusion.