9
Start & stop switches.
The switches are used to start and stop the machine.
Serial and data plate.
This plate is mounted on the back of the machine.
Where to locate your Machine.
Before you unpack your machine, select the area where you will use your machine.
There are no hard and fast rules for its location, but, below are a few guidelines.
1.
There should be an area around the machine suitable for the length of wood that
you will be machining.
2.
Adequate lighting. The better the lighting, the more accurate and safely
you will be able to work
3.
Solid floor. You should select a solid flat floor, preferably concrete or
something similar.
4.
Close to power source and dust collection.
Unpacking your machine.
To unpack your machine, you will need tin snips, knife and a wrench.
1.
Using the tin snips, cut the banding that is securing the machine to the
Pallet [if fitted].
WARNING: EXTREME CAUTION MUST BE USED BECAUSE THE
BANDING WILL SPRING AND COULD CAUSE INJURY.
2.
Remove the box from the Jointer. The parts will be packed at the side of the
plainer.
Note.
The machine is heavy, and if you have any doubt about the
described procedure, seek professional assistance. Do not attempt any
procedure that you feel is unsafe or that you do not have the physical capability of
achieving.
Note.
To remove the plainer from the box you will need 2 or more people.
3.
Slide the plainer so that it overhangs the pallet. Tip the plainer so that it touches
the floor. Slide the pallet from under the jointer, and lower the jointer to the floor.
Assembly & set up.
Mobility kit.
Mobility clamp screw
Mobility wheel
The mobility wheels come pre-fitted to the base of the machine.
The wheels are locked by tightening the clamp screws on the outside of the body.