Wide blade putty knife
Job
Packing Clamp
25
Loading a program into the machine
The controller has a USB slot located to the top.
1.
Load your program into your USB drive.
2.
Fit the USB into the USB slot in the controller.
3.
Press the button RUN PAUSE/ DELETE. The display will show U disc.
4.
Press the OK button. This will load onto the screen what is in the USB drive.
5.
Use the arrow keys to select the file that you need to load into the controller.
6.
Select, then press OK button.
7.
Once the code / program has been downloaded the machine will start to operate.
Note:
Ensure that you are clear of the machine as the spindle will start to turn
and could cause injury.
8.
The router will just cut the surface of the spoil board the distance that you set
in the design software, [we suggest 1.6mm [1/16”]] and cut the outline of the job.
This will give you the location of the part on the spoil board.
Removing the Job from the Spoil Board
The job has a tendency to stick to the spoil board and it is suggested that you use a wide
blade putty knife to lift the job.
Fitting the Job to the Table Using the T Slots
You may find it convenient to clamp the job to the spoil
board with the table clamps. This attachment method
can only be used if the outside edges are not being
machined.
When using the clamps, place a piece of packing under
the jacking bolt to protect the bed of the machine.
Содержание Laguna Series
Страница 2: ......
