laguna JX12 Sheartec:II, Руководство пользователя

Страница: 21 / 56

21 JX|12 & JX|16 Sheartec:II Jointers \ Setup Assembling
Adjusting the Fence
The fence can be adjusted to use all or a portion of the cutterhead. To adjust, loosen the Fence Slide Lock
(Fig. 14) and slide the fence to the desired position.
NOTICE! Secure both locks when fence is in position.
DANGER!
DO NOT OPERATE JOINTER WITHOUT LOCKING THE FENCE!
FIGURE 14: FENCE COMPONENTS
FIGURE 15: FENCE ANGLE ADJUSTMENT COMPONENTS
To adjust the fence perpendicular or angled to the
bed, loosen the Locking Lever (Fig. 16) and adjust
the fence to the desired position.
The 90-degree position has an included reference
STOP (Fig. 15). To adjust, flip the stop into position,
loosen the lock nut and rotate the adjusting screw
until the fence is at 90 degrees to the table. Tighten
the lock nut and flip the stop back if making other
angled adjustments. To check the 90 degree
setting, place a square on the outfeed table and
against the fence.
Auxiliary Fence
The auxiliary fence is used for better control and push-pad clearance, when jointing low material or when
material is better controlled by a low fence (Fig. 14A & B). To operate this fence, with power OFF, slightly
lift from top of main fence to unlock and rotate until it is securely against the table and side of the main
fence. When not in use, rotate to top of fence and lower on top of fence to lock in place.
FIGURE 14A: AUXILIARY FENCE
LOWERED
FIGURE 14B: AUXILIARY FENCE IN-
USE