laguna 18bx, Руководство пользователя

Страница: 34 / 70

34
Adjusting the blade guides.
The blade should run through the center of
the rear blade guide, and the sid
e guides
should be parallel with the blade. If they have
been moved out o
f adjustment, adjust as
follows :
Top Upper Side Guides Parallel
Adjustment
.
Loosen the side guides and move out as far as
possible. Loosen the guide assembly and
move back away from the blade.
Move the back blade guide forward so it just
touches the back of the blade and lock in
position.
Loosen the guide clamp screw that allows the
side guides to move forward and back. Adjust so
that the ceramic blocks are just behind the gullet
of the teeth and are parallel to the blade.
Retighten the clamp screws.
Gently push one side guide so that it touches the
blade and lock it in position. Bring the other
guide toward the blade so that there is minimal
clearance between the blade and the guide. You
can put a thin piece of paper to put between the
blade and the guide to obtain the correct
clearance until you gain experience. Tighten the
clamp screws and remove the paper. Rotate the
blade by hand, ensuring that the weld of the
blade does not hit the ceramic blocks, as this will
cause damage. If the blade has a bad weld,
dress the blade or return it to your supplier.
Rotate the blade by hand and check that the
back of the blade does not hit the blade guide
with a bad weld. If the back of the blade hits the
back blade guide at the weld, then dress the
blade or, in excessive cases, return the blade to
the supplier.
Side guide clamp screw
Back guide clamp screw
Back guide touching the back of the
blade
Adjusted guide