14
Fit the support bars to the sliding table.
Note:
The bars can be fitted in a number of positions to
suite the log that you are cutting. It is suggested that two
bars are fitted to either end of the sliding table, and the
remaining two bars are fitted evenly spaced between the
outer bars. It is recommended that two bars are fitted
opposite the log clamps.
Fit the log clamps to the sliding table.
Note:
The log clamps can be positioned in a number of
positions to suite the log that you are cutting.
Remove one sliding table stop.
Slide the sliding table onto rail.
Two or more people are required to fit table. Take care not
to exert side pressure on the bearing as you fit the sliding
table, or the bearings will be damaged. Once the table has
been fitted, fully tighten the bearing screws, and check that
the table slides smoothly. If the table runs tight, loosen the
bearing screws, readjust and then retighten the screws.
Refit the sliding table stop.
If only one person is available for fitting the table. Do not fit
the bearings, log clamps or the bearings to the sliding table.
Slide the bearings onto the steel bar. Place the table onto
the top of the bearings.
Adjust the position of the bearings and the sliding table to line up the fixing holes,
and fit the screws. Then fit the support bars and the log clamps. This is a tricky
option and it is not recommended unless necessary.
Sliding table stop removed
Liner bearing
