Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
961005
10
REV042023
INSTALLING/CHANGING BELT
1. Make sure machine is not connected to power source.
2. Use key to unlock and open belt access door.
3. Turn belt tension lock knob counterclockwise to loosen lock
collar and release belt tension lever.
4. Move belt lever down and toward drive motor and release
belt tension.
5. Remove old belt (in installed) and replace with new belt. Be
sure the new belts arrow matches the direction of rotation of
the machine.
6. Move belt tension lever up and away from drive wheel to
raise motor and tension the belt.
7. Check and adjust belt tracking after installing new belt. See “FISRT RUN” section of this
manual.
CHECKING/ADJUSTING BELT TRACKING
1. Make sure machine is not connected to power source.
2. Use key to unlock and open belt access door.
3. Standing in front of machine rotate either wheel by hand so the belt moves in the direction of
rotation of the machine (counterclockwise on wheels and towards work rest)
a. If belt moves left on wheels (towards motor): Rotate belt adjustment knob
counterclockwise 1/4 turn.
b. If belt moves right on wheels (away from motor): Rotate belt adjustment knob
clockwise 1/4 turn.
4. Repeat step 3 until belt tracks in center of wheels, once done close access door.
5. Connect machine to power and verify belt is tracking correctly, fine-tune tracking as
necessary while machine is running.
6. Once tracking is fine-tuned turn the machine OFF and loosen the work rest lock knob to
adjust to work rest so that there is no more that a 1/16” between the rest and the belt.
Tighten down lock knob to secure.
