Dake Corporation
1809 Industrial Park Drive
Grand Haven, MI 49417
14
983113
REV112020
OPERATIONAL CONTROLS
•
Emergency button ©. When the emergency button is
pressed, the saw belt will stop. (When returning power, turn
© to make it jump)
•
Power button (S), ON / OFF / Power lamp indication, 3
functions.
•
The VR rotary button © controls the speed of the bandsaw.
•
Speed display (P), you can directly see the current line
speed of the bandsaw.
•
Motor overload protection lamp (D). When the feed speed of
the sawing workpiece is too fast, causing the motor to run at
over-rated current, the overload protection lamp © will light
red and slow down the saw belt speed to reduce the motor
load, if the re-cutting is continued continuously, the system
will stop directly and do overload protection.
•
Lower limit switch (T), when the saw bow is lowered to the bottom, it will touch the lower limit
screw to stop the saw band.
•
Power socket (L), for users to use external work lights or other accessories.
HELPFUL CUTTING TIPS:
1. The more hardness of the material is, the slower the cutting speed.
2. When the saw is stuck on the work piece, please stop the saw action, reverse the saw
belt to slowly withdraw from the work piece, and do not perform the second sawing on
the same sawing path. If the sawing path is repeated, the saw teeth wear will cause
serious damage to the tip of the entire bandsaw and will result is a low quality cut.
3. When the blade speed is high, additional cutting oil is recommended.
4. To control the descending speed of the hydraulic cylinder, you can control the flow of
the throttle valve. Turn clockwise-the flow becomes smaller-the speed becomes
slower, and counterclockwise-the flow becomes larger-the speed becomes faster.
Drop too fast and damage items.
5. When using a new saw blade, it is necessary to carry out a saw-tooth running-in
procedure, which can prolong the service life of the saw blade and increase the sawing
efficiency.
6. When using your band saw always change the blade speed to best suit the material
being cut. The material cutting chart gives suggested setting for several materials.
