Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
988050
10
REV032023
Upper Blade Wheel Adjustment (Item B & C):
If the saw should get out of adjustment and the
blade runs off the wheel or runs back against the lip,
1. Loosen the two bottom bolts on the wheel side.
2. Turn the set screw in or out to make the blade run approximately 1/32” away from the lip
on the back of the wheel.
3. Tighten the two wheels slide bolts.
NOTE: If the blade can run against the lip on the wheel it will wear the lip off.
MAINTENANCE
Lubrication
-
The gear box is filled at the factory. Check the oil level upon arrival of the machine and
six months thereafter. This is in the small sliver cup after opening the side panel of the
base, if there is visible oil in the cup no refill is needed. Use 90 weight gear lube to
maintain fluid level.
TROUBLESHOOTING
SYMPTOM
CAUSE
SOLUTION
Saw is not cutting straight
Blade tension is too low
Increase blade tension
