Quick Reference For Spa Set Up
Read and Understand all Instructions Before Using Your Spa
1.
Locate Spa on a level surface that will support 3,000 lbs.
2.
Fill Spa to cover top jets.
3.
Remove front panel, remove the cord. Place through the slot on the access panel. Replace panel.
4.
Plug the G.F.I. cord into a 20 amp Dedicated 110 volt circuit receptacle.
5.
Avoid using extension cords.
6.
To heat Spa, set to desired temperature and close the covers, initial warm up time will 24 to 48
hours or more depending on conditions, on a 110v line. For a four hour approximate heat up time,
have an electrician convert the Spa Pack to 220V.
7.
Do not unplug the Spa as there is a daily automatic 2 hour filter cycle. The spa will automatically
maintain set temperature as required.
8.
Jets can be turned off individually. After Spa use, be sure most jets are open for good filtration
and heating.
9.
2 valves on the Spa top are to put air bubbles to the jets.
Содержание TS-100
Страница 1: ...INSTALLATION INSTRUCTION MANUAL...
