UNICO 01.02.2013
English / Englisch
Fig. 65
Using a suitable screwdriver
with a continuous
blade
and using a few light taps of your hammer,
loosen the screws of the bearing unit of the sand-
ing disc wheel.
Fig. 64
Undoing the five fastening screws of the attach-
ment.
Fig. 63
Unscrew the belt-tensioning screw all the way
out.
Fig. 62
Place the UNICO down on the
left-hand
side only.
Always
set the UNICO down on the
left-hand
side (Fig. 62)!
This will prevent damage to the floor, and the shape of the
fan housing also stops any dust falling back out of the dust
bag from getting into the fan housing.
4
To relieve the V-belt tension, use the proper Allen key to
unscrew the belt-tensioning screw all the way out until this
screw disappears on the front side in the threaded hole of
the fan housing (Fig. 63).
5
Use the proper Allen key to undo all five screws with which
the attachment is installed on the fan housing (Fig. 64).
6
Push the attachment all the way back and remove the five
screws with which the attachment is installed on the fan
hous ing.
Please note that the fan housing including the motor
could tip over!
7
Remove the attachment and place it including the belt pul-
ley facing downward in flat position on a suitable working
surface.
Do not place the attachment down on the wooden
floor! You could damage the floor!
8
Set a suitable screwdriver
with a continuous blade
on the
screws of the bearing unit of the sanding disc wheel. Use a
few light taps of your hammer on the screwdriver to loosen
these screws (Fig. 65)!
ATTENTION: risk of injury!
7
MAINTENANCE WORK AND REPLACEMENT OF WEARING PARTS
35
Содержание UNICO
