Lafe CEG007, Инструкция по эксплуатации

Страница: 11 / 34

Instructions for use
11
Electric
Kettle
EN
a) To heat up water to 60°C
Press and hold down [fig G] button until LED at a value of “60” has switched on.
Kettle interior is green illuminated
b) To heat up water to 70°C
Press and hold down [fig G] button until LED at a value of “70” has switched on.
Kettle interior is blue illuminated
c) To heat up water to 80°C
Press and hold down [fig G] button until LED at a value of “80” has switched on.
Kettle interior is yellow illuminated
d) To heat up water to 90°C
Press and hold down [fig G] button until LED at a value of “90” has switched on.
Kettle interior is violet illuminated
e) To boil water (to 100°C)
Press [fig F] button.
Kettle interior is red illuminated
6. Once the set temperature has been reached or water has been boiled, the kettle automati-
cally switches off and a short acoustic signal is produced.
7. Thanks to the base and a simple power terminal, the water may be poured from the kettle
without the need to turn it off.
8. Water may be poured from the kettle without lifting the lid.
9. Irrespective of the set operation mode, press [rys. F] button to interrupt kettle operation
(a short acoustic signal is produced).
NOTE: Always lift the kettle by the handle, as its housing tends to heat up.
Water filter
Kettle is equipped with a water filter that can be removed and washed if needed.
Protection against overheating and against turning on without water.
Kettle is equipped with a modern controller, which protects it from overheating when used
several times in a row.
The kettle is also equipped with a safety feature that turns it automatically off when there is
no water inside. In this case, when turned on, the kettle automatically switches off after about
30 seconds and the backlight turns off inside of the kettle. You should then remove the ket-
tle from the base and put the switch in “0” position. After refilling with water, the kettle will be
ready for use.