Thank you for purchasing a Lafayette product.
In order to make the best of our product, please read carefully the following instruction manual.
warning
Do not try to transmit if the antenna has not been connected, this could seriously damage
the transceiver.
This equipment has been calibrated and tested at factory; do not open it and try to tamper
with its internal components.
Connecting the antenna
The lead-in antenna cable must be terminated with a PL-259 connector. Only use antennas
tuned on 27MHz and use a RG-58/U shielded cable with a typical impedance of 50 Ohm.
Microphone bracket
Install the microphone bracket in a conformable position inside the vehicle, making sure that
the cable or the microphone itself do not interfere with driving operations.
Interference caused by the distribution system of your vehicle
Modern cars no longer cause problems for the shielding of distribution cables and ignition sy-
stem, therefore the transceiver should not suffer any interference caused by engine operation.
•
•
Standard features include:
Function
Built-in noise blank and automatic noise
limit circuit
Strong dynamic microphone with ASQ
control button
Large scale, easy reading multifunction
LCD display
Dual function selection button design
Frequency or channel number display
Beep sound ON or OFF
Instant recall for the last used channel
Manual squelch control and automatic
squelch control system
Scanning and 4 channel memory
Dual watch function
Emergency channel 9
1�
2�
3�
4�
5�
6�
7�
8�
9�
10�
11�
Please note that the use of the equipment is subject to authorization for the purposes indicated
in article 334 of P.T. code (Italy only).
Controls
AF volume control w/ On/Off Sw
Squelch control
Channel up/down control
lcd display
Channel / frequency
Tx/BP/Dw/SC
Memory Channel 1 - 4
AM/FM/AQ
12 bar level meter
3.5 mm external speaker jack
SO-239 antenna connector
Dynamic microphone & 8 pin jack
Led backlight ( blue )
Noise squelch
1�
2�
3�
1�
2�
3�
4�
5�
ENGLiSH