Manh Truc Wood Pole Panel Drape Installation Instructions 2
INSTALL THE WOOD POLE WITH PANEL DRAPE
5. Holding pole on both sides of the panel drape to
prevent sliding, lift and slide large metal groove of
pole onto left or right side locking tab of wood
bracket. Opposite side should clear bracket, then
slide onto its locking tab also. (C.)
6. Screw finial onto both ends of wood pole.
7. Slide lock stop to stationary rail side and tighten
to secure stationary rail against the bracket. (D.)
INSTALL THE PANEL DRAPE
- If no center support is necessary, skip to step. 1.
If a center support is needed, with the small groove
in the back of the decorative pole facing up on a flat
surface, drill a 3/4” hex head screw into the groove,
centered evenly between the ends.
- Slide bracket onto screw and tighten snug. Unscrew
1/2 turn and remove support bracket. Continue to step 1.
1. Lay fabric facedown on a flat, clean surface.
2. Insert fabric carriers into the wood pole. (A.)
3. Slide lock stop into the track between the 1st
and 2nd carrier from the end. (Do not tighten) (B.)
4. Carefully slide panel drape to the center of the pole.
18-5704-01 August 2016
CARE AND CLEANING
- Light dusting is recommended for Manh Truc fabrics.
Because the Manh Truc materials are “natural” and
include grasses, reeds and bamboos cleaning with
water or any detergent is NOT recommended. Dusting
with a vacuum attachment can be done with extreme
care on low suction. The lining materials for Manh Truc
can be spot cleaned using warm water and detergent.
Do NOT immerse the lining in water.
A.
B.
C.
D.
- If you have a center support, slide center support onto
screw on the back of the wood pole.
- Hold in place while securing center support screws
into the wall.
Note:
You will need to tighten one screw
into the bottom hole and one into the top hole of
center support from the bottom of the pole at a slight
angle.
