VitalsBridge Directions for Use
19
rev. A.5
3.
Attach the blue tubing to the blue luer lock (CO
2 in
) to the VitalsBridge. To ensure a secure connection between
the regulator and the VitalsBridge, twist the luer fitting at least 180 degrees to the left before inserting the luer
into the metal port on the VitalsBridge. Then twist to the right until it is tight.
4.
Orient the VitalsBridge so the threaded connection on the regulator can be seen. Hold the regulator in one
hand, align the cartridge under the housing, and quickly turn it clockwise into the regulator. Do not stop until
tight. Do not over-tighten; the cartridge only needs to be hand tight. It is normal for a small burst of gas to leak
out during cartridge installation.
5.
Replace the regulator back on the bracket that is attached to the VitalsBridge instrumentation.
6.
SLOWLY turn the regulator knob clockwise until the indicator on the gauge reads between 15-20 PSI. Do not set
the regulator to a reading higher than 20 PSI.
Содержание VB100
Страница 1: ......
