laerdal Nursing Kelly, Инструкция по применению

Страница: 5 / 100

E
n
g
l
is
h
Intubation
The following equipment is recommended:
a. Endotracheal tube, size 7.5 ID or smaller
b. Manikin Lubricant spray or liquid soap
c. 10 ml syringe
d. Laryngoscope blade, size #2 or #3 straight or curved
e. Laryngoscope handle
f. NG Tube, size 16 French
Remove trach plug prior to insertion of intubation tubes.
Intubation tubes and airway passages should be sprayed with manikin
lubricant spray or lubricated with liquid soap prior to intubation.
Chest Plate
To remove:
1. Apply pressure to center of plate.
2. Work your fingers under edge of plate while lifting.
To insert:
1. Position plate over cavity.
2. Work plate edges into groove on torso cavity.
Lungs
Lungs may be removed from bronchial tubes by unscrewing them at the
connector site. To replace, reverse procedure.
Stomach Reservoir
The stomach reservoir attaches to esophagus with a connector. Unscrew
reservoir from esophagus to fill or drain with water.
Belly Plate with Multi-Sounds
To remove:
1. Apply pressure to center of plate.
2. Work your fingers under edge of plate while lifting.
3. Disconnect bowel sound speaker connector to release plate.
Dusting with talcum powder is helpful in replacing belly plates.
To insert:
1. Position plate over cavity.
2. Reconnect bowel sound speaker.
3. Work plate edges into groove on pelvis cavity.
Belly Plate with Colostomy Stoma
To remove:
1. Apply pressure to center of plate.
2. Work fingers under edge while lifting. (Photo 2)
Photo 2
To insert:
1. Attach valve and genitalia.
2. Work plate edges into pelvis cavity.
The belly plate with colostomy also serves as the urinary reservoir.
To fill reservoir:
a. Remove colostomy stoma.
b. Fill with fluid.
c. Gently reinsert stoma.
Make sure genitalia and urinary connectors are in place prior to filling.
Injection Pads
a. To remove, squeeze pad with fingers and pull.
b. To replace, squeeze pad and insert in opening.
Dusting pads with talcum powder will assist with reinsertion.
Injection pads may be injected with water. Foam should be removed from
pads immediately following training. Squeeze out fluid and air dry.
Waist, Knee and Ankle Joints
These joints are connected with a bolt and lock nut. To remove, unscrew
lock nut and pull bolt from joint. Segments will now easily disconnect.
When assembled, talcum powder should be used in joints to assist
articulation.
Arms
Arms are attached with a 4,5” long bolt, three washers, a spring and a wing
nut.
Attachment hardware is located in envelope inside carton.
To attach:
1. Remove chest plate.
2. Locate hole in shoulder.
3. Remove deltoid injection pad from arm by squeezing skin in center of
pad while pulling.
4. Slide small washer over bolt.
5. Insert bolt through hole in arm and hole in manikin’s shoulder.
6. Add large washer, spring, another large washer and wing nut to bolt.
(Figure 1)
Nursing Kelly 3 Laerdal