laerdal HeartStart FRx Trainer, Инструкция по применению

Страница: 8 / 112

FRx TRAINER 861307
8
To set up the FRx Trainer
To install or replace the batteries
The HeartStart Trainer is powered by four AA alkaline batteries (not included).To
install or replace the batteries, follow the steps below:
1. Press the latch on the battery compartment door on the back of the FRx
Trainer. Lift off the door and set it aside.
2. Remove the old batteries and recycle or dispose of in accordance with
your local regulations.
3. Insert four new AA alkaline batteries into the recess, oriented as illustrated
in the battery holder.
4. Replace the battery compartment door and press down to ensure the latch
holds it in place.
NOTE: It is recommended that you replace all four batteries at the same time.
To connect or replace the Training Pads II
To connect the Training Pads II to the FRx Trainer, simply plug the Training Pads II
connector into the connector port of the FRx Trainer. Be sure the connector clicks
into place.
When the original training pads have reached the end of their service life, you can
order Replacement Training Pads for the training pads case.
To install replacement training pads in the reusable training pads case, remove and
discard the old pads from the case. Open the Replacement Training Pads II package
and remove each training pad from the disposable liner. Repack the replacements
pads in the reusable case according to the following directions.
FRx Trainer 10-04-07 15:11 Page 8