Lacanche CITEAUX INDUCTIONLVI 1532 E / CT, Руководство пользователя

Страница: 24 / 36

USER’S MANUAL
INDUCTION HOB
Induction unit are fitted with :
- a rotating encoder control that gives 9 power selections
- an electronic display of the power being used.
- 2 warming positions (at approximately 42°C and 70°C in the recipient).
- Accelerator to pre-selected heat setting and then automatically switches to the preset power
level.
- Booster function.
- Child safety function.
- Overheating cut out.
Note : Each ring is fitted with a waste heat indicator lamp. These
lamps light up a short time after the corresponding unit has been
switched on and go out when the heat in the zone of the ring
has dropped to a value that no longer constitutes a risk to users
(approximately 60°C) : Is the Message « Hot ».
A ventilator is located underneath the table, to refresh air for an
optimum power of all units.
Use :
Place food in pan.
Place the pan on the desired cooking zone.
Turn the control knob of the ring required (clockwise).
The power level is set on the display.
To use function accelerator, from position
0
, turn the knob anticlockwise couple second (the letter
A is displayed) then turn clockwise to the desired setting. Level 9 will automatically be engaged for
as long as it taken to reach the pre-selected setting (This is the accelerator).
Note
: One or more zones may be selected.
As heating is very rapid, select the target heat required immediately (i.e. no need to increase heat
in stages).
The various positions are best suited to the following examples of cooking operations :
1 & 2 = Keeping food warm or preparing sauces.
3 & 4 = Gentle simmer or maintain cooking.
5 & 6
= Sustained simmer or cooking pasta or rice once water has boiled.
7 = Frying.
8 = Browning or seizing meat.
9 = Bring to or maintain rolling boil.
P = Booster = Brings liquid to boil quickly.
A = Potency level 9 during time to reach the temperature of the level
preset then commutes automatically at the level of potency chosen.
u = Assertion in temperature (42°C).
U = Assertion in temperature (70°C).
Observation
(Note : , , are on figure previous page).
The booster function can be applied to the zone at the same time as using the booster on
and , but not all 3 simultanously.
The booster function cannot be applied to both zone or irrespective of when then as in
use or not.
When the booster function is used on , and then is turned on to boost, the electronic
indicator for will flash a couple of times and automatically revert to power setting 9 . will
remain on boost. The reciprocal applies.
0
u
U
P
N
iv
ea
u 1
à
3
A
N
iv
ea
u
7
à
9
Niv
eau 4
à 6
Citeaux induction - Ft 158a - GB - Rév 06 - Modifié le : 07/10/2013 24/36