Labrie MINIMAX, Руководство по обслуживанию

Страница: 39 / 174

General Maintenance 31
Figure 3-12 Removing the packer
8.
On the packer control station, press the yellow P
ACKER
R
ETRACT
button to retract the cylinder
(see Figure 3-13).
9.
Install any safe lifting device and hook the packer by the ring handle (see Figure 3-12).
10.
Pull the packer out of the side rails and place it in a safe work area.
Figure 3-13 Packer retract button
Replacing Packer Wear Plates
When the packer wear plates are worn out, you must replace them to achieve packer optimal
performance.
To replace the wear plates, proceed this way:
1.
Remove the packer from the body. See Removing the Packer on page 28.
2.
Once the packer is placed in a safe work area, cut off the wear plate panel (see Figure 3-14).
Warning!
When you pull out the packer, always ensure total clearance until it is placed in a safe area
to avoid any accidents.
Cylinder pin
Ring handle