- 17 -
4.
To enable sample labeling use the navigation keys to select
“Sample Labeling”
and press the ENTER
key. Use the navigation keys once again to enable or disable sample labeling. Once a desired selection
is made press the ENTER key.
“Sample Labeling”
applies to the “Automatic Mode” only. It allows the user to assign a unique name
to a sample which is then stored in the scales database. When set to
“OFF”
the scale will not assign or
display names of the samples.
5.
To assign a
“Quick Key”
use the navigation keys to select
“Quick Key”
and press the ENTER key.
Use the navigation keys to select a desired quick key (F1 through F5). Once the desired key is selected
press the ENTER key to accept the selection.
If the key is not available (used by a different function) a warning message will be displayed
“Warning Quick Key Already In Use!”
To override the key press ENTER. To abort and select a
different function key press the CLR key.
6.
To configure the scale’s display during parts counting use the navigation keys to select
“Display
Setup”
and press the ENTER key. To disable information from displaying during the function use the
navigation keys to highlight the desired selection and press the ENTER key to remove the check mark.
Once the check mark has been removed the information will not display while performing parts
counting.
7.
To exit Parts Counting set up use the navigation keys to select
“Exit”
and press ENTER.
Содержание Torbal AG100
Страница 70: ... 69 Chapter 12 Technical Information ...
