Hardware
NXT Go Owner’s Manual, LBL-00145, MAN2030
98
Remote Control NXT Battery Replacement
To replace the Remote Control NXT battery:
Use a Philips screwdriver to unscrew the two screws on the battery door at the
back of the Remote NXT.
Remove the used battery and replace it with the new battery. Ensure that there is
correct battery contact orientation. Always use 3xAAA batteries.
Place the screws in the two screw holes on the battery door and tighten the
screws to secure the battery door using a Philips screwdriver.
6.4 NXT Go Pump Hub
The NXT Go Pump Hub (Figure 77) includes: the Infusion Pump NXT, pump controls, and
the SmartSense tag reader. Refer to the diagram below for key parts and controls.
Figure 77: NXT Go Pump Hub
The NXT Go Pump Hub must be connected to the power supply, the laptop, and the NXT Go
Infusion Hook to function. Ensure the NXT Go Pump Hub appears in the
Device Manager
.
Infusion Pump NXT
The Infusion Pump NXT on the NXT Go Pump Hub is used to fill the patient’s bladder with
fluid during Urodynamic Study. The maximum pump rate of the Infusion Pump NXT for 7
French catheters is 70ml per minute.
The interface on the NXT Go Pump Hub provides access to pump stop control, the
SmartSense tag reader, and LED indicator lights (Figure 78).
LABORIE LOGO Indicator
Pump stop button
Pump status arrow
SmartSense tag reader
Figure 78: Status of the Pump
For information on setting up the pump tubing, refer to the
NXT Go Infusion
Hook Input
Laptop USB
Connector Cable
Input
NXT Go Power
Cable Input
Infusion
Pump NXT
Control
Panel
NXT Go – Front View
NXT Go – Rear View
Status DRAFT Effective
