Labomed Lx 400, Руководство пользователя

Страница: 5 / 32

Fig. 1
SAFETY SYMBOLS
The following symbols are found on the microscope. For optimal use, it is recommended that users
Understand these symbols and always use the equipment as prescribed.
Symbol Explanation
This surface has a tendency to heat up and should not be touched unless
System has completely cooled down.
Before use, carefully read the instruction manual. Improper use could result in
Injury to the user and/or damage to the equipment.
Main switch is ON.
Warning against risk of electric shock.
Main switch is OFF
.
|
!
SAFETY INFORMATION
1. After the microscope has been used for observation of a speci
-men containing bacteria, clean all parts coming in contact with
the specimen to prevent infection.
• Be sure to remove the specimen before moving this product.
• In case the specimen is damaged by erroneous operation, it is
important to clean all surfaces that may have come in contact
with the specimen.
2. To avoid potential electrical hazards when replacing either halo
-gen bulb or LED, turn the microscope main switch to the OFF posi
-tion and disconnect power cord from wall outlet in advance.
Whenever you replace your microscope bulb, allow lamp socket
and bulb to cool before touching (Fig.1)
Applicable bulb/LED replacement: 6V20W Halogen bulb P/N CX-013; 6V30W Halogen bulb P/N EL-455 or
LED P/N 9135000-901
3. Install microscope on a sturdy, level table or bench and avoid any restriction of air vents in the base of
the unit.
Do not place microscope on a flexible surface, as this could result in blocking the air vents and cause
overheating.
4. Always use the power cord provided by LABOMED. If the proper power cord is not used, product safety
performance cannot be warranted.
5. When installing the microscope, route the power cord away from the microscope frame. Should the
power cord come in contact with the microscopes base, the power cord could melt due to overexposure
to heat.
6. Always ensure that the grounding terminal of the microscope and that of the wall outlet are properly
connected. If the unit is not grounded, LABOMED can not warrant electrical safety.
7. Never allow metallic objects to penetrate the air vents of the microscope frame as this could result in
user injury and damage to the microscope.
8. After operation of microscope, be sure to disconnect power cord from connector socket of the microscope
or from the wall power outlet.
2
Lx 400
2
9126000-795 Lx 400
Issue 1.5
Printed on April,2019