BA_084_2019-05_10.00 Temperature transmitter clamp-on
Page 10/20
6.2.4
Display layouts
You can configure the layout of the measured value display as well as the displayed infor-
mation individually. There are four different layouts available:
Designation
Layout
Description
Example
Four values
Under the main value, three additional
values are shown. The 4th value can
use the entire display width.
Three val-
ues
Under the main value, two additional
values are shown. Both of them can
use the entire display width.
Two values
Two values are shown in the same
size, one under the other.
Large dis-
play
The main value is shown at the maxi-
mum size (best readability from a dis-
tance). One additional value can also
be shown.
Table 4: Display layouts
You can define what information shall be shown
in the layout’s placeholders.
You can select the 1st value (main value) from the following data:
1. Temperature with the selected unit
2. Pressure in per cent of the measuring range
3. Pressure in milliampere
For all further values, you can additionally choose from the following data:
Bar graph
Device ID (see 6.4.9.1)
HART tag
HART descriptor
When information (such as the device ID) cannot be displayed in a short layout placehold-
er, "###" appears on the screen. Then select another layout or assign the value to a longer
layout placeholder.
You can configure the screen mode in the menue "Display" submenue "Screen mode"
(see 6.4.4.2).
