Instruction Manual |
1
1.0 Introduction
The Labnet Digital Incubators have been designed for general purpose incubations (<65°C), as well as those applications requiring
higher temperatures (up to 65°C).
Temperature within the incubator is controlled and regulated by a microprocessor. Temperature is set and displayed digitally. An
independent, user settable safety thermostat protects samples and the incubator from overheating in the unlikely event of a primary
controller failure.
A fan, located in the chamber, assists in providing an exceptionally uniform environment. The fan also speeds temperature recovery
after the door of the incubator has been opened. For applications where the flow of air in the chamber is undesirable, the fan may be
switched off.
The interiors of the 311D and 611D incubators are constructed of stainless steel. The exteriors are made of cold rolled steel to resist
corrosion and provide strength. The door of the incubator consists of two parts. The inner door is glass to allow for viewing the
chamber contents without disrupting the temperature environment. The outer door is solid and insulated. It is also heated to help in
maintaining the chamber temperature. The heated door prevents condensation from forming on the inner glass viewing door.
2.0 Safety Information
These units are high performance incubators for professional, industrial, or educational use where the preparation or testing of
materials is done at approximately atmospheric pressure and no flammable, volatile, or combustible materials are being heated.
These units are not intended for hazardous or household locations or use.
Your satisfaction and safety require a complete understanding of this unit. Read this instruction manual thoroughly before attempting
to operate the incubator. All operators should be given adequate training before using this incubator.
NOTE:
This equipment must be used only for its intended application. Any alterations or modifications of the incubator may void the
warranty and may result in injury.
The electrical warning symbol indicates the presence of a potential hazard which could result in electrical shock.
This symbol indicates a potential risk and alerts you to proceed with caution.
CAUTION:
To avoid accidental bodily harming or burning be very careful touching the metal parts of the unit. It can be
very hot after it is used at high temperatures. Allow the metal parts to cool down before handling.
3.0 Specifications
Temperature range
Ambient, +5°C to 95°C
Temperature uniformity
I-5311-D
I-5611-D
±0.2°C at 37°C
±0.25°C at 37°C
Temperature accuracy
±0.2°C
Temperature set/display
Digital
Temperature control
Microprocessor
Overtemperature safety
Independent, settable
Interior outlet
1 AMP
Door
Inner: glass
Outer: solid, heated
Temperature uniformity
I-5311-D
I-5611-D
2.75 cu ft (77.9L)
6.0 cu ft (169.9L)
Exterior construction
Cold rolled steel
Interior construction
Stainless steel
Exterior dimensions (D x W x H)
I-5311-D
I-5611-D
27 x 20 x 29 in. (68.6 x 51 x 73.7 cm)
31 x 26 x 34 in. (78.5 x 66 x 86.4 cm)
