Please take note:
This Quick Guide is not a replacement for the manual. It is only a brief
overview of the functions of the alarm system. Detailed information
about the alarm system can be found in the manual. The correspon-
ding safety chapter of the manual is an integral component of this
document. The safety instructions contained therein should be read
and understood.
General Safety Instructions
The responsibility for the design, installation, implementation, opera-
tion, maintenance and dismantling lies with the system operator. The
installation and implementation of all devices must only be carried out
by trained specialist personnel. The protection of operating person-
nel and the system is not guaranteed if the module is not used for its
intended purpose. The laws and regulations applicable to the use or
intended purpose must be observed. The devices are only approved
for proper and intended use. Infringement will void any warranty and
manufacturer’s liability.
Installation of the Alarm System
The device can only be installed outside of potentially explosive areas.
The unit cannot be installed in places where aggressive vapours may
be present. The device must be disconnected from the power supply
during installation and maintenance. The alarm system should only be
connected to the supply voltage after the sensors and relay outputs
have been completely mounted and connected and the protection
cover fitted. The type plate must not be removed.