Labelmate ZCAT-6, Руководство пользователя

Страница: 4 / 62

Labelmate - The World’s Leading Manufacturer of Label Dispensers, Rewinders, Unwinders, Slitters & Counting Solutions
SET-UP
• Remove the two Phillips screws from the hollow end of the QUICK-CHUCK. Place the Label Flange Plate on the QUICK-
CHUCK by placing the hole of the Flange Plate over the Boss of the QUICK-CHUCK, and reaffixing the two screws
through the Flange-Plate and into the QUICK-CHUCK.
• Slide the hollow end of the QUICK-CHUCK onto the ZCAT Motor Shaft allowing for clearance to the Chassis and Motor
Screws. Tighten the Allen Screw of the QUICK-CHUCK onto the flat part of the Motor Shaft until it is tight.
• Set the unit in place near the printer.
• Verify that the “RUN/STOP” switch is in the “STOP” position, and that the Torque Adjust Knob is turned counterclock-
wise all the way down.
• Place an empty label core onto the QUICK-CHUCK of the ZCAT Rewinder and press snugly in place against the Label
Flange Plate.
• Turn the red knob of the QUICK-CHUCK clockwise to expand the QUICK-CHUCK and affix the empty core firmly in place.
Getting started
A
B
g
D
C
F
E