12
REPLACEMENT OF THE WIRE SPOOL (FIG E&F)
1.
Unplug the power socket.
2.
Turn up side down the unit, so to have the head on top.
3.
The cover closing the nylon spool is just clipped. Push the retainer
located on spool holder and turn the cover (1) of spool holder (3).
4.
Remove the empty spool (2).
5.
Clean the spool and the inside part of the spool holder from any
dirt, dust, grass waste, etc.
6.
Insert the new spool into the spool holder. Operate a slight
rotation to put in proper position.
7.
Insert the wire end (4) through the opening. The wire length
should not be more than 10 cm.
8.
Fix the cover with the new spool on the spool holder. Make sure
that the retainer fits exactly into the slots of the spool. Its engaging
is noticeable. If you do not succeed, turn the spool back a little
and fix the cover again.
FIX NEW WIRE ON SPOOL (FIG G)
The original replacement wires are available by our dealers or in
our agreed after sales service stations..
Remove the empty spool from the trimmer as described here
above.
Remove from the spool the remained not used wire.
Insert 1 cm of new wire (4) in the opening (5) in the bottom part
of the spool, as indicated.
Wind the nylon wire on the spool in the direction indicated by the
arrow (6).
Make sure that winding is regular and well placed. Never cross the wire! Fix the nylon
wire in one of the 2 slots on the upper lip of the spool.
Finish the assembling, fix again the spool on the trimmer, as described here above.
Do not forget to take out the nylon wire from the final slot.
Attention ! Use only genuine wire. Never use metal wire!!!
