Addendum 2 to La Spaziale S1 Instruction Manual
Note: Applies only to S1’s shipped on or after 2/20/2004 or older units with upgraded PC board
New Incremental Temperature Control Instructions
The La Spaziale S1 instruction manual describes how to select the temperature in 5°C increments.
However, once you set this control to 85°C, 90°C, 95°C, 100°C, 105°C, 110°C, or 120°C as your master
temperature, you can enter the fine temperature control mode which allows you to adjust the temperature
relative to the master temperature in 1°C increments up or down as far as ±3°C.
Here are the steps required to successfully program in ±1°C increments:
(
BOLD
= lamps,
Reverse
= buttons)
1. The S1 must be in Standby mode; i.e. the green
ON/STBY
lamp is blinking. If not already in this
mode, momentarily press the
ON/OFF
button.
2. Press and hold the
Two Cup
button in for 3 seconds until both the yellow lamps over
100
and
105
are steadily lit. This condition indicates an offset of 0°C from the master temperature setting.
(If any of the green lamps, the other yellow lamp, or the red lamps are lit at this time, a non-zero
offset has previously been programmed.)
3. To increase the temperature, press the
BOILER
button. The first press lights the yellow lamp
over
110
which ind1°C. A 2nd press also lights the red lamp over
120
which indicates
+2°C. A 3rd press also lights the red lamp over
ECON
which ind3°C. A 4
th
press of the
BOILER
button extinguishes all three lamps indicating that the machine has cycled back to 0°C
offset from the master setting.
4. To decrease the temperature, press the
One Cup
button. The first press lights the green lamp
over
95
which indicates -1°C. A 2nd press also lights the green lamp over
90
which indicates
-2°C. A 3rd press also lights the green lamp over
85
which indicates -3°C. A 4th press of the
One
Cup
button extinguishes all three green lamps indicating that the machine has cycled back to 0°C
offset from the master setting.
5. When finished, press the
Two Cup
button until the lamps extinguish. You will be back in Standby
mode with only the
ON/STBY
lamp blinking. At this time, your setting is memorized and will
remain until you repeat the above procedure to change it.
If, for example, your master temperature setting before entering the fine temperature control mode is
95°C and you press the
One Cup
button until all three green lamps are lit, the water temperature is
programmed to 92°C. When back in normal operational mode with the green 95°C lamp lit steadily, the
water temperature will actually be 92°C.
NOTE: The master temperature setting and the fine temperature setting are completely
independent. If you have set the temperature to 92°C, as in the above example, and later decide
you want the temperature to be 100°C, changing the master setting to 100°C will result in 97°C
water temperature because the fine temperature setting is still at -3°C.